Installation Instructions

Helpful Hints

Harnessing Your Dog

Position your Soggy Dog over top back and
one lower corner of seat to ensure most accurate placement of slit.

Chose which base of seatbelt you will be harnessing into. 
Tilt the base in the direction it will be pulled once the seatbelt clip is engaged. 
This prevents the fabric being pulled sideways once you clip into your seatbelt.

Cut the slit only to the width of your seatbelt’s metal clip
so the base of the seatbelt stays below the fabric.

Cut slit in a vertical direction – not horizontally (door to door).

Allow the elastic to pull the sides of the Soggy Dog  up
and create a “catch all” on either side of seat. 

This pocket will fill with sand and hair,
instead of allowing it to run down into your vehicle.

and you're done.

Don't forget to Buckle Up Your Baby!

 

---

Water Repellent Dog Car Seat Covers
Dog Car Seat cover Protection for your Car, Truck, SUV or RV
& Water Resistant Dog Bed Covers